January 19, 2022

DIY Car Servicing Tips For Those Who Like A Challenge

DIY Car Servicing Tips For Those Who Like A Challenge

If you’re the kind of person who loves a challenge, then DIY car servicing is definitely for you! This blog post will explain the process of servicing your car at home. It’s not as hard as it might seem – with a little bit of effort, you can save yourself a lot of money on servicing fees. We’ll provide you with all the information you need to get started, including tips and tricks for making the process go more smoothly.

Change Engine Oil and Filter

The first step is to change the engine oil and filter. This simple process can be done with common tools found in most homes.

To change the engine oil and filter:

  • Ensure that the engine is not hot.
  • Loosen the drain plug on the oil pan and allow the old oil to drain out.
  • Replace the drain plug and tighten it securely.
  • Remove the old oil filter using an oil filter wrench by turning it counterclockwise. If you do not have an oil filter wrench, a large pair of pliers can be used instead.
  • Apply a thin layer of clean motor oil to the new filter.
  • Screw the new filter onto the engine until it is snug. Do not over-tighten.
  • Pour fresh motor oil into the engine through the fill hole on top of the engine. Be sure to use the correct type and weight of oil as specified in your owner manual.
  • Check the level of engine oil, and add more if necessary.

Start the car and ensure that the new oil filter works properly and there is no leak.

Change Air Filter

  • Locate the air filter housing. It is usually located on the side of the engine and will be marked with an “Air Filter” sticker or label.
  • Open the air filter housing by releasing the clips or screws that hold it in place.
  • Remove the old air filter and discard it. Be sure to wear gloves when handling the old filter, as it may be dirty and contain harmful particles.
  • Install the new air filter, ensuring that the arrows on the filter are pointing in the correct direction.
  • Close the air filter housing and secure it in place with the clips or screws.
  • Start the car and ensure that the engine is not making any noises.

Change Spark Plugs

  • Locate the spark plugs on your engine. They will be situated in the cylinder head and marked with a “Spark Plug” sticker or label.
  • Remove the old spark plugs by unscrewing them from the engine. Be careful not to drop any of the screws into the engine.
  • Install new spark plugs by screwing them into the engine. Ensure that they are tight, but do not over-tighten them.
  • Start the car and check for any abnormal noises or vibrations. If everything is okay, drive the car around for a few minutes to ensure that it is running smoothly.

At The Key Online – Lawton, serving Lawton, OK, we recommend that after you buy a used car, don’t forget to service it regularly. Regular servicing will make your vehicle last longer. Also, if you are willing to purchase a used car, check out our inventory of high-quality and reliable cars online.


Return to blog